Anycubic Photon Printer Owners 造訪社團 » 用戶發文

Is there a video demonstrating how to remove, or even just unplug, the motor from the Photon? I looked around and couldn't find one. The Anycubic tech support guy wants me to test the motor, but it looks like the plug is glued in and I don't want to risk going at it with a knife and damaging anything.

翻譯年糕

So I have a concern with my 3D prints - after a print job I'll notice that there is a thin layer of partially-cured resin on the FEP, which I can scrape up without too much issue, and I will sometimes have thin sheets/flaps of the same on the models that I print, though neither of these things really seem to affect the print quality. Is this normal, or do I have some settings to mess around with?

翻譯年糕

So I bought a Photon and, after waiting an unreasonably long amount of time to actually receive it (which is unrelated, but adds to my frustration), I started printing with it. The quality was great, everything was working like I expected it to, but then within three days of getting the printer I'm having a Z-axis malfunction, where it just won't move.

I've looked online and have seen a lot of similar issues, but in all of them the printer's fans and LCD are also malfunctioning. In my instance the fans and LCD work fine, and it's just the Z axis that won't move. I've tried power cycling and updating the firmware to no avail.

It might be relevant to note that I had a print going while I was out and about, and when I returned the print appeared to be partially-complete, still attached to the build plate, and the build plate was all the way up at the top of the Z axis.

I have relatively little experience in troubleshooting hardware, so how would one go about figuring out what the issue is?

翻譯年糕