Anycubic Photon Printer Owners 造訪社團 » 用戶發文

I've had the printer a couple weeks and the the first few prints went pretty well. Had a fail so I took the vat out, cleaned it out, strained the resin etc. I've since not had a print that would stick to the build plate to finish, it will print about 3-5mm and fall off. I've cleaned out the tank after each fail, re-leveled, and tried making a wider base on the models and still no luck.

Here's my settings:
Thickness .05mm
Exposure 8s
Off time 1s
Bottom layers 8
Bottom exposure 50s
Anycubic green that was supplied with the printer

翻譯年糕

10ft of UV tape held into the printer packaging with bits of PETG bent up like staples. Hooray for recycling! Curing a resin soaked rag before disposal.

翻譯年糕

Ran the test print last night and had some very thin film like flakes a random spots on the print. Not the end of the word, just wondering what causes that issue. I'd assume their test print would have all the settings pretty well dialed in already?

翻譯年糕