Hiya team. I'm having a bit of a grrrr moment. I am outputting 1/10 and 1/25 model car parts but am getting visible layers. I just looked through that earlier post where everyone is showing the best detail they have gotten off their printers and it is bloody amazing what some of you can do. In these pics are a diff cap, drum brakes, uni joints and springs in 1/10, also uni joints and springs in 1/25 (the springs were too damn fine and trying to remove the supports pre-cured just trashed them unfortunately). You will see in the pics the lines I am talking about. I am currently thinking exposure time might be off? I am using a photon S as well, and the exposure test that I found at the hub was only for the original photon it seems. Is there one for the S available? I'm using Monocure rapid gray resin.
Any help you peeps can offer would be greatly appreciated.
翻譯年糕
Richard Humble
2019-09-01 16:41:00
Greg Noonan
2019-09-01 16:48:52
Richard Humble
2019-09-01 16:50:43
Chasen Harris
2019-09-01 17:21:55
Chasen Harris
2019-09-01 17:22:53
Greg Noonan
2019-09-01 17:35:00
Chasen Harris
2019-09-01 17:38:36
Greg Noonan
2019-09-01 17:45:15
Daniel Meyer
2019-09-01 17:59:06
Daniel Meyer
2019-09-01 18:01:57
Greg Noonan
2019-09-01 18:05:26
Greg Noonan
2019-09-01 18:06:09
Daniel Meyer
2019-09-01 18:10:37
Mike Roof
2019-09-02 00:18:28
Greg Noonan
2019-09-04 22:29:38
Mike Roof
2019-09-04 22:36:26
