Anycubic Photon Printer Owners 造訪社團 » 用戶發文

原文網址 Daniel Gallagher
2019-09-13 08:14:38

So I received a replacement (presumably brand new) Photon from Amazon yesterday and the lcd seems to be failing after one successful print. I noticed something was wrong when the machine would continuously beep during the first layer and not move onto the second. The UV test (square) will illuminate momentarily before going out. Testing UV again with machine still on shows no UV square and only the blue lights beneath the lcd. Shutoff machine and retry and the test illuminates only momentarily, exhibiting the same behavior I'm thinking maybe a short in the lcd? I've opened up the machine to confirm the lcd cable is firmly attached to the board and tested on multiple firmware versions. Makes no difference. I'm guessing this is a failed lcd but figured i'd post up here to see if maybe i'm just missing something...

翻譯年糕

Tiernan Messmer
2019-09-13 08:20:06

Jarrod Smith
2019-09-13 08:24:11

Daniel Gallagher
2019-09-13 08:29:37

Jon Vogel
2019-09-13 09:51:03

Daniel Gallagher
2019-09-13 09:59:42

Jarrod Smith
2019-09-13 11:12:31

Daniel Gallagher
2019-09-13 11:26:43

原文網址 Daniel Gallagher
2019-09-07 09:24:25

Anyone had this happen to their Photon? I just got this printer yesterday and it appears the sticker wasn't adhered to the unit properly when packing and ended up getting packed with the sticker folded over. I've tried glue, sticky tack and masking tape and nothing will hold it in place. Either the top will come unstuck or the bottom. One or the other. I know it's only a sticker but it also appears to protect the front lcd. Anyone have any good glue suggestions?

翻譯年糕