I just got an anycubic and yesterday I got the print bed leveled and did my first test print and it came out great! I did see what looked like one of the base layers floating around in the resin vat though. Anyways every print after that prints were only sticking to half of the print bed. I cleaned it off and looked at it and it looks like there is a small gouge in the plate which is causing the print bed to not be completely leveled on one side. If I file it down do I need to seal it at all or is the exposed aluminum ok to be in the resin?
翻譯年糕
Jason Dickson
2019-09-08 22:18:57
Nathan Kopp
2019-09-08 22:27:48
Chamberlain Skeksil
2019-09-08 22:45:05
Terry Andrews Jr.
2019-09-08 22:56:30
Jon Lamkin
2019-09-09 00:02:17
Jeff Beute
2019-09-09 01:38:37
Stefan Giudici
2019-09-09 10:06:20
Jeff Beute
2019-09-12 03:27:54
Jeff Beute
2019-09-12 03:28:50
