I just got my printer and in an effort to reduce the smell and toxic material I decided to get some esun bioresin grey. I then ran the exposure text with the results below. It looks like a fail at the 2-20sec test. The 6-60 sec test doesn't look much better. The best results look to be between 5-6 (30-36sec) even then the results do not seem as good as what other people have gotten. Could this be a bad batch of resin?
Note: the 2-20sec sheet has little holes in it as right after the print finished I ran the build plate assembly under hot water to clean off the uncured resin.
翻譯年糕
Stefan Giudici
2019-09-16 08:50:25
Stefan Giudici
2019-09-16 08:52:24
Mark Mosley
2019-09-16 08:54:12
Smith Hayward
2019-09-16 09:37:30
Smith Hayward
2019-09-16 09:38:06
Alex Kung
2019-09-16 10:45:57
Alex Kung
2019-09-16 10:48:51
Roby Ellis
2019-09-16 17:48:43
Allan Johansen
2019-09-16 20:03:06
Bob Deblier
2019-09-16 20:05:39
Alex Kung
2019-09-16 20:10:29
Bob Deblier
2019-09-16 20:11:02
Alex Kung
2019-09-16 20:15:13
Bob Deblier
2019-09-16 20:16:22
