• #maker+t=market
  • 3D列印服務
  • COSPLAY 3D 建模
  • 1
  • 2
  • 3

Anycubic Photon Printer Owners 造訪社團 » 用戶發文

原文網址 Vedran Kalamiza
2020-04-02 23:01:16

I find that I have to re-tighten the FEP after every print. The screws become loose. Would some 3M Blue solve this, or is it some other issue, like the lift speed? I have increased it to 300mm/min as per Tom Sargison's guide.

翻譯年糕

Christopher Barton
2020-04-02 23:59:48

.

罗西晟
2020-04-03 05:18:05

Do the screws become loose or does your FEP stretch?

Higher lift speeds cause more force pulling the prints off the FEP.
Yes your print is faster but if you lower your speeds you can get successful prints when it would otherwise might just barely break your builds off the supports.

Vedran Kalamiza
2020-04-03 13:20:57

Bolts definitely come loose. FEP is still taut, but less than before.


原文網址 Vedran Kalamiza
2020-03-09 13:49:38

What is causing this slight bend in the right edge of the cube right above the inner strip with lettering - see the shadow? The rest of the cube is fine at this level.

翻譯年糕

Bob Deblier
2020-03-09 13:57:28

Simon Vo
2020-03-09 21:37:33


 

討論主題

全不選 常用關鍵字