Anycubic Photon Printer Owners 造訪社團 » 用戶發文

Most people want to know how to color translucent resin or make it opaque. I'd actually want to make my opaque resin somewhat translucent, anyone got any ideas how to? and or if it is possible at all?\

翻譯年糕

Had an interesting failure today...

Was printing a mini, and left and right the parts stuck to the buildplate, but the center where the mini was it stuck to the FEP.

What makes it weirder is that "just" before this mini, I had a print that was only on the center of the build plate and that succeeded.

Checked my FEP, it's at 300Hz so that's ok.

Cleaned my buildplate (this time manually with alcohol wipe, rather than in the Anycubic washer and let it dry)

For now I just re-leveled the printbed (home, down till I cant move buildplate, tighten, raise buildplate 0.3, set z=0.

And adjusted initial cure from 50 sec to 60.

Anything tips on what (else) I should check?

(I suspected a concave build-plate but already checked that.)

翻譯年糕

My Photon (and wash&cure) arrived!
(Don't mind the mess, still cleaning up the space)

Resins:
Anycubic black, white & translucent green

Prepped a special corner in my boilerroom so that the fumes get extracted by building ventilation(extractor)

Already leveled the bed and set z=0...

Used to have a reprap so not new to 3d printing, only new to resin printing.

Already got the exposure test and z-wobble test downloaded.
Just prepping some more stuff (supported mini's) to be printed before I start.

Think I'll want to start with the Anycubic test file... Though photon validator sais it has floating islands, not sure if I'd have to fix those....

翻譯年糕