Taking any and all thoughts, I am new to resin 3d printing and was wondering about the post print cure. I have a piece to an electric sander that broke and I was wondering about using one of my printers to replace it. The problem is that the piece appears to be made of nylon and has a thin cross section ( about 0.100" diameter). Additionally looking at one of the pieces that didn't break it is meant to flex. I do not have any nylon filament nor do I plan on buying any as the sander is cheap. My question is that if I make the piece with the photon but do not do the secondary cure will the piece keep its form just stay soft or is the secondary cure necessary for the structure to stay together? So far my limited knowledge of resin printers is that the material is very brittle and I was not sure if that was just a result of the printing process or the secondary cure?
翻譯年糕
Tim Sherwin
2019-10-08 19:30:45
Brian Kailimai
2019-10-08 19:36:20
Brian Kailimai
2019-10-08 19:38:04
Francisco Rebolledo
2019-10-08 19:43:49
Brian Kailimai
2019-10-08 20:38:50
Nipuna Gunarathne
2019-10-08 22:23:30
Brian Kailimai
2019-10-09 02:33:45
