Anycubic Photon Printer Owners 造訪社團 » 用戶發文

Hi All , I'm having a horror weekend trying to get anything to print . Previously printed parts using the same file on the same usb stick with the same resin . Parts directly on the build plate . Listening to the prints they are stuck to the plate thru the bottom layer stage and then coming off the plate part way thru , or getting all the way thru and getting a bunch of extra print wiping out the last layers . Std Photon using Monocure grey and clear resin with the same results . The "sheet" in the 1st pic measures pretty much spot on with the max X and Y . Not sure if it has any bearing but last weekend when I printed this part temps here were in the high 20's to low 30's C , this weekend has been up in the high 30's . Anyone got any thoughts/ideas ??

翻譯年糕

Hi Guys , got my first 2 prints of the Photon today , I'm calling them a success since they came out the machine in 1 piece , but there is a couple of areas I could use some advice on please . 1st 3 pics , the back edge (red circle) appear's to have sagged as well as what appears to be sagging on top sorta flat surface , Im guessing not enough supports ?? . Other thing that caught my eye is the random height lines parrellel to the print plate , I did pause the print a bunch of times to have a look see at how it was going , any possible connection ?? Last pic , this printed well except for the very bottom on the print bed , the bucket was set at 3mm above the plate in the slicer but it looks as if that was to close and the lot just sort of stuck together and turned into a solid mass , bit more angle on the bottom of the bucket and get it higher off the print bed ???. Monocure Clear resin 0.04 layer @10sec , 6 Bot layers @100sec 6.5sec off time .

翻譯年糕