What's the best way to print circular coin-like objects? I tried angling them at 45 degrees, but the circular shape causes the first part of the model to act as a lever against the few supports it has at that point.
Then i tried laying them flat like I would on an FDM printer, but I guess the Z cross section was too big because that had failed supports and warping.
Should I print them on their side straight up and down? Here's a screenshot for reference.
翻譯年糕
Marc de Hoogh
2019-10-25 03:38:07
Josh N Bee
2019-10-25 04:00:12
Harold Crossley
2019-10-25 04:43:39
Raphael Truffi Bortholuzzi
2019-10-25 04:57:49
Aaron McCommon
2019-10-25 05:15:30
Aaron McCommon
2019-10-25 05:16:59
DJ Brookshire
2019-10-25 05:50:44
DJ Brookshire
2019-10-25 05:56:37
Raphael Truffi Bortholuzzi
2019-10-25 05:56:38
DJ Brookshire
2019-10-25 05:57:05
Raphael Truffi Bortholuzzi
2019-10-25 05:57:58
DJ Brookshire
2019-10-25 05:59:04
Raphael Truffi Bortholuzzi
2019-10-25 05:59:58
Raphael Truffi Bortholuzzi
2019-10-25 06:00:57
Josh N Bee
2019-10-25 06:24:43
DJ Brookshire
2019-10-25 13:31:38
Marc de Hoogh
2019-10-25 13:33:26
