I know it's really really really hard to tell from photos, but I'm guessing I'm not supposed to be seeing the UV backlight at all though the masked off parts? I know light bleed is common in TVs and these phone screens they use aren't designed to be blasted with 25w UV lamps. Is this normal on the photon? I keep getting a bunch of resin stuck to FEP. Not in places where anything is supposed to print. It isn't a giant sheet across the whole FEP, it's pieces here and there. And it's after every print. Sometimes the print itself is fine, many times there are extra pieces hanging off the print, sometimes it fails in weird places. I'm charging up my other phone so I can record the whole print and see if I have glitches in the middle of a print.
You can see in the pics with paper over the screen that there is a faint glow in the masked parts.
Can I solve this? Yes I have checked the cable is seated. The fans are all working. This has been happening on all different firmwares, official ones, Epax 4.2.18, even phontonsters GUI mod. My motherboard failed and was replaced as well, happened on the old Mobo and the new one.
For those curious this is Bluecast x10, sanded buildplate with bluecast primer cat adhesive, all settings they suggest. (0.05 layer, 9 seconds, 60s bottom layer, 40mm/hr lift speed). Room is at 21°c-25°c. Resin is warmed initially to around 30°c. I get the same kinds of results on all resins.
翻譯年糕
Dan Hjulberg
2019-11-07 05:55:47
Mike Hatem
2019-11-07 05:58:09
Dan Hjulberg
2019-11-07 05:59:06
Mike Hatem
2019-11-07 06:01:46
Paul Stuff
2019-11-07 07:42:16
Susan Sioux Mercer
2019-11-07 08:05:33
Susan Sioux Mercer
2019-11-07 08:07:09
Stefan Giudici
2019-11-07 08:26:03
Mike Hatem
2019-11-07 08:37:24
Mike Hatem
2019-11-07 08:39:01
Mike Hatem
2019-11-07 08:40:10
Susan Sioux Mercer
2019-11-07 08:45:03
Mike Hatem
2019-11-07 08:45:29
Mike Hatem
2019-11-07 08:47:30
Susan Sioux Mercer
2019-11-07 09:13:34
Stefan Giudici
2019-11-07 09:15:53
Mike Hatem
2019-11-07 09:18:11
