Hey folks! Total amateur question here but it's got me baffled! Just got myself a printer in the last week set it up, paper test done etc etc. But when setting the Z=0 it says it's decided by the trigger position rather than what the manual says, anyway you confirm this and try to print and it sticks to the bottom rather than the build plate. Any ideas on where I'm going wrong? Thanks in advance!
翻譯年糕
Nipuna Gunarathne
2019-11-02 16:57:19
David Nisbett
2019-11-02 18:48:24
Alex Vee
2019-11-02 18:54:34
Alex Vee
2019-11-02 18:56:43
Nipuna Gunarathne
2019-11-02 19:09:28
