Anycubic Photon Printer Owners 造訪社團 » 用戶發文

原文網址 Alessandro Tonin
2019-12-11 08:25:14

Hi guys, is there any guideline to correctly place the supports? Right now I'm using the autosupport from Chitubox, but often they are a lot and I have some problem on removing them. Moreover I'm not sure which settings I should put for the supports: thickness? shape of the point? shape of the support?

翻譯年糕

Brian Todoroff
2019-12-11 08:36:59

Bert Harvey
2019-12-11 08:40:24

原文網址 Alessandro Tonin
2019-12-07 04:56:21

Dear all,

After a while I finally got my first successful non-test printing (Alexander the Great as Helios)! Thanks a lot to everybody!

I used anycubic green resin, bottom exposure 90s, layer exposure 15s (but I think the model is overexposed)

翻譯年糕

Sydnee Davidson
2019-12-07 05:02:12

Alessandro Tonin
2019-12-07 05:05:21

Sydnee Davidson
2019-12-07 05:07:04

原文網址 Alessandro Tonin
2019-10-28 21:00:33

Hi, yesterday i just printed my first cube with my new anycubic. Here it's the result... I would say that is good but sometimes there are some mistakes, like a thin layer between the grid of the cube.. Do you know why this is happening?

翻譯年糕