Anycubic Photon Printer Owners 造訪社團 » 用戶發文

Question: has anyone experienced problems with anycubic orange resin? I have green, and it's working perfect, every print is ok. But for orange i had to go with some sick values for expo, to have it stick to my build plate. But even then if i print 4x same model, only few of them are printed fully. Some don't stick, some have supports but model is left in the vat. Resin expiration date is ok, i was wondering if it's printer, but other resins work fine.

翻譯年糕

Hello guys,
i have received new motherboard from Anycubic due to T100 error. I have replaced it today but i can't open any file from my USB. There are empty squares when i pick "Print". Also the Z axis moves different, like the sound of the motor is not the same as it was previously. I have plug another USB directly to the motherboard, same problem. I remember that Z axis was working this way, when i was using test files from Photonsters, while we were looking for perfect exposure timing. Maybe it needs some kind of restart or something? Or the motherboard is faulty?

翻譯年糕

I am looking for the most precise resin for printing small stuff. I go advised, that HARZ Model is very good, but the shrinkage is bigger than Anycubic resin. Can share your experience?

翻譯年糕

Guys need some help. Was calibrating my photon and print was satysfying. So i clone my model to print more at once and next day i saw some of the resin leftovers on the FEP. I have cleaned everything, mixed and poured new resin to the vat, but the result after printing was the same. The funny part is that the prints are fairly ok, maybe some surfaces are not the best, but they are fully printed.

I use Harz Model Black with settings:

Bottom Layer Count: 7

Exposure Time: 13

Bottom Exposure Time: 120

Light-off Delay: 1

Bottom Light-off Delay: 1

Can this be due to underexposure? Shall i try another resin, like anycubic's that i have parameters already check?

Any help would be nice, thanks :)

翻譯年糕