Anycubic Photon Printer Owners 造訪社團 » 用戶發文

Strange problem: Every time I press HOME the build plate goes up a little (about 10 mm) and it beeps. Never goes down. Resetting Z0 doesn't change anything. I even tried a reset with factory-defaults.gcode, it doesn't change ... ?

翻譯年糕

My printer had a major failure on startup. Ventilator stopped, the display still shines but nothing works, no Z move, no UV test, nothing. What happened??

翻譯年糕

Sometimes you really have to hang on: every new print was a even broader mess (I don't even show all messed prints). But the last two pictures show that in the end, you can. What happened between the first and the last picture: Re-leveled, changed from Anycubic orange back to green, re-leveled again, changed exposure, installed EasyZ0 and leveled again, adjusted the Z column to real 90°, re-leveled again, changed the FEP, re-leveled. Then first success with green, and then successfully with the flimsy but beautiful orange (exposure =15, base layers =100)

翻譯年糕

When relevelling the build plate, I stated that the Z column is not perpendicular to the red base plate. Not perpendicular at all. Is it normal? Can it be fixed?

翻譯年糕

My First ever Photon prints. No 1 stuck on the FEP. Scary experience for a beginner, but it's not so hard to remove, and now I know how to do it...
I guess that the build plate was still factory greasy, cleaned it with Acetone. The 2nd and 3rd print were not bad, but had somme Mesh errors.

No 4 & 5 were fine, but there was still a leveling problem on one corner of the build plate, but fortunately the support leveled this error away.

I made a new z0 again, increased the bottom layer exposure from 50 to 60 and turned the resin vat. Then No 6 came out absolutely fine.

So: 1/never give up 2/ clean a new build plate with hard stuff 3/ print with support when you can 4/ watch the mesh structure

I am making mainly Model train parts. This is a flimsy pilot ("cow catcher") and a streetcar front. Scale 1:87

翻譯年糕