Any thoughts that would help? I’m using Chitubox slicer with default settings for the photon. Raft printing looks good then I noticed some of my supports are printing in half circles instead of complete circles as you can see in the progressive pictures below. Any help is very appreciated.
翻譯年糕
Zena Andreou
2019-11-12 03:51:38
Paul West
2019-11-12 03:55:43
Hugh Jeriolas
2019-11-12 03:57:03
Greg Kourakos
2019-11-12 04:21:08
Ben Cox
2019-11-12 04:44:20
Mark Rhodes
2019-11-12 07:31:31
Vinicius Silva
2019-11-12 08:16:04
Ben Cox
2019-11-12 09:02:00
Ryan Evans
2019-11-12 09:59:56
Philippe Maegerman
2019-11-12 22:06:52
Tiernan Messmer
2019-11-13 08:39:24
Dexter WG
2019-11-13 11:40:15
Ryan Evans
2019-11-14 12:08:01
Dexter WG
2019-11-14 14:07:41
