Hey guys, just wanted to say hi and thanks for the add... only got my Photon yesterday and it was very nearly an expensive garden ornament as I couldn't get prints to stick to the bed. After cleaning off my 4th failure I noticed the FEP installed at the factory was not in a good way, looked like it had been creased before getting installed.
Anyhow it seems to be working now after a FEP change and several re-levels, but what a load of messing!! I'm also an Ender 3 owner so really dont mind trail and error but just feels with this resin lark theres no in between. It works or it's a sludgy mess in the bottom of the vat.
翻譯年糕
Nipuna Gunarathne
2019-12-01 04:15:42
Michael A Miller
2019-12-01 04:17:41
Paul Holmes
2019-12-01 04:20:57
Nipuna Gunarathne
2019-12-01 04:22:02
Paul Holmes
2019-12-01 04:22:48
Tyler Delaney
2019-12-01 04:27:17
Paul Holmes
2019-12-01 04:29:59
Tyler Delaney
2019-12-01 04:32:54
Kimberly Jacob
2019-12-01 05:01:21
Tyler Delaney
2019-12-01 05:03:24
Kimberly Jacob
2019-12-01 05:13:02
Paul Holmes
2019-12-01 05:16:50
Tyler Delaney
2019-12-01 05:19:02
Justin Leone
2019-12-01 05:27:17
Tyler Delaney
2019-12-01 05:32:05
Justin Leone
2019-12-01 05:36:33
Paul Holmes
2019-12-01 05:56:40
Melecio Guzman
2019-12-01 08:00:27
Frank Martinez Jr
2019-12-01 08:21:26
Frank Martinez Jr
2019-12-01 08:22:21
James Byer
2019-12-01 08:35:01
James Byer
2019-12-01 08:35:18
Dan Elent
2019-12-01 08:42:47
Dan Elent
2019-12-01 08:44:12
Paul Holmes
2019-12-01 11:31:27
Frank Martinez Jr
2019-12-01 11:38:08
Paul Holmes
2019-12-01 11:39:15
