Hi, new to Photon and 3d printing. Any ideas why the Photonia test is slanted from front to back (1.6x mm -> 1.2x mm) and columns are distorted on Y axis? Column sides perpendicular to X axis are straight. Also on two tests there is delamination happening on front side side (front is thicker at 1.6x mm). Done 4 prints with Anycubic Translucent Green with exactly the same end result - slant is always the same. I did level the bed 3 times between tests using different methods. Ball joint is clean and tight. Even when build platform is clamped into vice I could not shift the platform. I can feel some backlash on Z screw. Also platform caves in a bit in the middle (will have it lapped next week).
First test was done on 4.2.19.3 firmware, next three were done on 4.2.18 firmware.
Test #1 was done at default Photonia exposure (12sec), Tests #2 through #4 were done at 9s exposure adjusting according to exposure test.
翻譯年糕
Andy Chew
2019-12-06 20:09:03
Nipuna Gunarathne
2019-12-06 20:13:45
Alvydas Jatkialo
2019-12-06 20:15:39
