Hello all! I’ve been working to get some internal holes printed for this part, but can’t seem to get them all to print properly. Any advice on how to prevent the internal features from fusing? I ran the part at a 0.025mm after this one, but it didn’t resolve the issue. The paths are visible, but the holes are not just not defined the whole way through. Pardon my mess of supports...
翻譯年糕
Stephen Carr
2019-08-25 11:41:32
Scott Pavlich
2019-08-25 11:43:12
Sean Casteel
2019-08-25 11:47:08
Sean Casteel
2019-08-25 11:47:17
Stephen Carr
2019-08-25 11:58:43
Scott Pavlich
2019-08-25 11:59:53
Sean Casteel
2019-08-25 12:06:22
Sean Casteel
2019-08-25 12:08:22
Stephen Carr
2019-08-25 12:10:11
Scott Pavlich
2019-08-25 12:10:11
Sean Casteel
2019-08-25 12:14:11
Scott Pavlich
2019-08-25 12:19:50
Sean Casteel
2019-08-25 12:22:06
Richard Humble
2019-08-25 19:06:42
