Hi everyone. I have a question about Photon File Validator. I have been using auto-support in the Prusa Slicer as I was appalled by what was happening in auto-support in Chitubox! On smaller items there was the odd stray single pixel island but nothing to really worry about. But now I am printing something larger and the amount of islands has naturally increased. I add supports in Prusa, slice in Chitubox and send the exported .photon file to the validator. But now there are more islands and the message "blah blah but nothing can be done." appears.
I return to Chitubox and go to the layers delineated in the validator and for the life of me, I cannot see any islands. I go up a layer, and up a layer but still none appear. I'm beginning to doubt my sanity.
So is it OK to just print with these "islands" in the piece for which "nothing could be done" in the validator?
Obviously, once outputted as a .photon for the validator, I can't send it back into the Prusa Slicer...
Thank you *so much* to anyone who can shed some light on this. It's been driving me spare. I have gone through several YouTube videos but my work is somewhat different from the models used to teach with.
翻譯年糕
Ben James Couey
2020-03-19 08:11:06
Tim Moulton
2020-03-19 08:15:13
Larry McCauley
2020-03-19 08:24:06
Larry McCauley
2020-03-19 08:24:14
Ben James Couey
2020-03-19 08:30:04
Ben James Couey
2020-03-19 08:31:06
Ben James Couey
2020-03-19 08:36:36
Larry McCauley
2020-03-19 08:52:53
Larry McCauley
2020-03-19 09:18:28
Ben James Couey
2020-03-19 09:22:07
Larry McCauley
2020-03-19 09:44:46
Michael Pescuma
2020-03-19 10:17:19
Larry McCauley
2020-03-19 10:44:33
Larry McCauley
2020-03-19 10:50:57
Ben James Couey
2020-03-19 10:53:26
Larry McCauley
2020-03-19 10:58:13
Mario Wessely
2020-03-19 15:56:10
Michael Pescuma
2020-03-19 21:36:03
