Anycubic Photon Printer Owners 造訪社團 » 用戶發文

原文網址 Paul Flynn
2020-04-02 03:39:27

Help needed.
I was using siraya blu for the first time on my photon last night. Halfway through the print i paused it to see if it had failed - it had. So i cancelled the print and flicked off the power.

Today neither the uv light or z axis is working, i can hear and feel that the z stepper is receiving power but its not moving. Any simple solutions before i tear it to pieces?
Ps. I have checked the ribbon cable from touchscreen to the motherboard.
Thanks guys.

翻譯年糕

Matty J. Lim
2020-04-02 14:24:05

Have you tried reflashing or updating the firmware?

Paul Flynn
2020-04-03 08:18:42

Matty J. Lim thank you Matty, that worked a treat, back in the game ? ?

Matty J. Lim
2020-04-03 08:21:14

Paul Flynn very happy to hear that mate,

Paul Flynn
2020-04-03 08:24:42

Matty J. Lim i presumed (you know the saying) that the problem was either mechanical or electrical as i had been using it literally 8 hours earlier. I am a mechanical engineer, i can fix almost anything, but i hate software, i don't get it and i never want to ? . Thank you again my man ?

Matty J. Lim
2020-04-03 08:25:48

Paul Flynn haha fair enough and no problem :) happy printing and glad i could help

原文網址 Paul Flynn
2019-12-09 00:58:24

Hi guys,
My prints seem to be slowly creeping to one side as the print progresses. The print is supposed to be a dead straight cylinder and as you can see the bottom left and top right are offset from each other, any ideas? Ps. Printed direct to the plate.

翻譯年糕