Anycubic Photon Printer Owners 造訪社團 » 用戶發文

I am just wonderning how you can print jig for nintendo switch. I tried to do holes and build on plate. Always holes gets filled and print is ruined as I cannot put wire inside, any ideas?

翻譯年糕

Hi, is there somebody who do modeling of 3d prints? I need little one, please!

翻譯年糕

Have any of you tried to print something what has to have holes? Good example is jig for Nintendo switch I printed but holes are gone.

翻譯年糕

Hi, I found out water turbine and I am just thinking if is it safe to have it on your sink as I know resin is toxic but if its cured ? Thanks

翻譯年糕

Ok I have issues to get stick on first layer, it always end at bed. I am trying to print yennefer model with good support I would say.

I am using basic green resin from anycubic and I have photon S.

Here are my settings:

layer 0.05

normal exposure time: 8

off time 2

bottom exposure used to have 50 but i will test with 70

bottom layers 6

anti alias 4

z lift 6

z lift speed 3

retract speed 10

What could be wrong? i played with off time had 1 no change.

Temperature in basement is way lower than 30, even 25, about 21.

Any suggestion welcomed.

I calibrated bed more than three time and once I printed switch jig without any problem. But other than that nothing. I am getting frustrated to wait hours for nothing.

翻譯年糕