Anycubic Photon Printer Owners 造訪社團 » 用戶發文

原文網址 Kalob Porter
2020-01-12 09:46:41

First multi-part print! Turned out pretty good I think!

翻譯年糕

Ron Staton
2020-01-12 09:54:20

Kalob Porter
2020-01-12 09:57:24

原文網址 Kalob Porter
2020-01-02 22:03:28

Thanks for all the help! Finally getting some successful prints rolling out ?

翻譯年糕

Chad Cox
2020-01-02 22:13:49

Kalob Porter
2020-01-02 22:17:43

Kevin Robins
2020-01-02 22:37:13

原文網址 Kalob Porter
2019-12-30 02:33:03

Hi guys, thanks for the add. I’m at a total loss at what to do to get my builds to stick. My first test print (the lattice cube) came out perfectly, not a single imperfection. I used the Anycubic green resin, and the print right off of the USB that the machine came with.

I go to do my 2nd print, without changing anything, and it won’t stick. I’ve tried anywhere between 8 and 10 first layers, between 80 and 120s first layer exposure time, etc.

I can hear the print pulling off of the FEP for the first few layers, but it just falls off somewhere around 15-20 minutes after the print starts.

I’ve releveled the bed 3x using both flint reed and paper methods. Is it possible the model itself being messed up? It falls off before any supports are even printed it seems.

Attached is my first print for reference.

翻譯年糕