Need some help, have been around fdm for awhile but new to resin, I am having a "issue" where the bottom 2mm or so of my prints are larger then the rest and have like a foot effect. Normally this is not a problem since when printing on lifted models the supports are just enlarged, but when I need to print directly to the plate it is a issue. I was not sure how to search for a solution or maybe this is just over exposure? Resin is anycubic gray, 8 bottom layers at 70 seconds.
翻譯年糕
Luiz Junior
2020-01-02 11:55:48
Kris Leon
2020-01-02 11:57:56
Bill Jackson
2020-01-02 12:05:14
Kris Leon
2020-01-02 12:07:26
Aaron Strome
2020-01-02 12:38:06
Richard Humble
2020-01-02 16:35:43
