So I need some help! I’ve tried printing this about 5 times now. Always the same thing.
I printed with Anycubic green, it failed, I went in re levelled and set home, checked the supports and printed again.. fail.
Re levelled, erased my USB key, resliced and even ran it through the file validatior. It said that unsupported islands found in layer 60 and 279 ( no idea what that even means or how to fix ) I saved and tried the print again. Fail
Need some help please what can I do.
I’m trying to print a set of Recaro 1/24 seats I had designed.
What am I doing wrong?
翻譯年糕
Rok Petrič
2020-03-21 06:30:34
Matthew Fry
2020-03-21 06:31:17
Honestly I just had the same problem. Don't know if it would work for you but all I did was beef up the supports.
Frank Padula
2020-03-21 06:31:58
Frank Padula
2020-03-21 06:32:26
Matthew Fry
I was thinking about that.. I even hollowed before slicing
Rok Petrič
2020-03-21 06:33:30
normal exposure 12 exposure off 8s
Frank Padula
2020-03-21 06:37:20
Frank Padula
2020-03-21 06:38:14
Rok Petrič
2020-03-21 06:39:17
Adam Scaramella
2020-03-21 07:08:12
So I was using Elegoo Grey and was able to print with tiny contact diameters on the supports. This was based on a video explaining supports...it worked for him and worked for me at first.
I swapped to AnyCubic Green and had similar problems. My contact diameters are now both .22 for my heavy supports, and only slightly lower for the light ones. My printing got immediately better.
Fred Bey
2020-03-21 07:39:05
Exposure is probably too low.
Frank Padula
2020-03-21 11:06:23
Adam Scaramella
yeah. I think that’s what the problem is here. Because the supports are intact looks like they just fell off
Brklyn Brklyn
2020-03-21 11:13:17
You need to tilt the seats 20 deg. I like to use a good amount of heavy supports and pin all the details with the smaller ones.
How big are you layers? Thicker lays need more cure time. I use .03 @ 9sec for the green.
Kasper Boysen
2020-03-21 17:18:10
F
Frank Padula
could you please let me know if you figure out what the problem was?
Frank Padula
2020-03-22 02:31:25
Kasper Boysen
I’m going to reprint soon.. I will post hopefully the success pictures lol
Kasper Boysen
2020-03-22 02:32:08
