There is a lot of awesome stuff going on in this page! I love seeing it. I do have a problem of course. I just got my Photon and have tried 3 times to print. It failed all three times. I have leveled it and re-leveled it after watching many videos. My prints stick to the film and not the build plate. It seams to me it's the first layer, but I am new at this. I use the grey resin, i didn't change any settings in my slicer. I downloaded the slicer from anycubic. any suggestions would be appreciated.
翻譯年糕
Franz Meriles
2020-01-04 01:09:38
Mark Mosley
2020-01-04 01:10:02
Scott Walter
2020-01-04 01:13:41
Keith Yinger
2020-01-04 01:14:07
Keith Yinger
2020-01-04 01:15:23
Scott Walter
2020-01-04 01:16:18
Joseph Wright
2020-01-04 01:22:46
Ray Sears
2020-01-04 01:22:47
Harry Colquhoun
2020-01-04 01:24:20
Scott Walter
2020-01-04 01:27:48
Harry Colquhoun
2020-01-04 01:32:10
Scott Walter
2020-01-04 01:34:47
Melecio Guzman
2020-01-04 01:47:49
Ash Bostock
2020-01-04 01:48:27
Shawn McDonald
2020-01-04 01:49:56
Harry Colquhoun
2020-01-04 02:02:47
Ash Bostock
2020-01-04 02:15:40
Chad Elstad
2020-01-04 02:39:09
Bob Deblier
2020-01-04 04:29:40
Scott Walter
2020-01-04 06:09:34
Scott Walter
2020-01-04 06:10:36
Bob Deblier
2020-01-04 06:12:05
Scott Walter
2020-01-04 06:18:37
Scott Walter
2020-01-04 06:20:21
Chris Thompson
2020-01-04 08:07:51
