Anycubic Photon Printer Owners 造訪社團 » 用戶發文

原文網址 Sean Guna
2020-01-20 06:25:38

Almost a full week of printing..... this is my first 500ml bottle worth of minis. Only a few support issues but not fails since the first day.

Anycubic Photon S
Anycubic Gray
Layer Height: .05 (did one at .03 but didn’t see much difference)
Bottom layer: 6
Exposure: 14s
Bottom Exposure: 100s
Light off delay: 1s
Temp in house: 70f/21c

Oriented and initial supports on auto in Prusa (75% density). Edited all bad supports that would cause errors and added more as needed. Exported with supports into Chitubox.

Verified any missing supports again, hollow (as needed for bigger items) and holes (as needed).

翻譯年糕

Daniel Quinn
2020-01-20 06:54:16

Michael Ray
2020-01-20 07:19:16

Sean Guna
2020-01-20 07:25:53

Sean Guna
2020-01-20 07:27:28

Daniel Quinn
2020-01-20 07:39:08

Julie Cheung
2020-01-20 08:39:35

Sean Guna
2020-01-20 08:41:39

Ben Brooks
2020-01-20 09:08:30

Julie Cheung
2020-01-20 09:12:08

Sean Guna
2020-01-20 09:16:46

Ben Brooks
2020-01-20 09:19:19

Sean Guna
2020-01-20 09:20:16

Justin Hernán
2020-01-20 10:21:16

Sean Guna
2020-01-20 10:26:25

Ben Rawalt
2020-01-20 10:32:07

Sean Guna
2020-01-20 11:09:21

Sean Guna
2020-01-20 11:11:47

Callum Sidley
2020-01-20 15:47:19

Sean Guna
2020-01-20 15:55:00

Callum Sidley
2020-01-20 16:08:58

Sean Guna
2020-01-20 16:16:32

Callum Sidley
2020-01-20 16:21:55

Sean Guna
2020-01-20 16:29:41

原文網址 Sean Guna
2020-01-12 23:43:40

Edit: Cube completed. :)

Good morning (evening or afternoon depending where you are). First time printing today after setup. I noticed something odd that confused me this morning.

Followed all the setup and advice from both the Photonsters FAQ and the amazing Photon Guide and Tips.

The question - my test cube was not defaulted to file type .photons and on my computer was showing as a 3D File (STL (edit: it was an OBJ file not an STL)). I'm thinking my computer automatically converted it; but was there a step I missed that said to slice it into their software?

So this of course brought up other questions: Since it is pre-sliced I shouldn't just pop it into the slicer and slice it... (and yes I saw that someone has uploaded the test file to the group a few times).

So is this normal? Is my computer just converting files or did I miss a step where it said slice the cube first?

Anyway - great community so far. I can find almost all answers throughout here. This is more of a hey - new guy is here and thanks for the add than a HELP obviously.

翻譯年糕