I have a fauxton.
It has worked just fine using the settings from the spreadsheet with the anycubic green it came with but i'm about to move on to the anycubic purple eco-resin and there are no settings recorded yet. Likewise, as a fauxton, it cant use the photon calibration test from github.
Is the any test i can use with a Fauxton?
Or does anyone either have good settings for purple eco-resin?
thanks in advance
翻譯年糕
Vedran Kalamiza
2020-03-18 16:49:38
If the so-called "Fauxton" is the Photon S innards in the Photon case, simple logic would suggest that the Photon S test can be used.
Christopher King
2020-03-18 16:57:55
I thought fauxton has the original Photon LED rather than the upgraded -S version. i figured that would mean different print times and therefore the -S calibratoin test wouldnt be accurate. But I dont know ,hence the enquiry
Tim Borschel
2020-03-18 17:09:14
I'm pretty sure the fauxton just has the photon s motherboard, everything else is the same as the photon.
Tim Borschel
2020-03-18 17:10:15
If you cant read the .photon file you need to upgrade the firmware to 5.x.xx or whatever the v5 firmware is
Christopher King
2020-03-18 17:21:42
its not the .photon file im having a problem. its gcode for the resin xp finder off github. I'm hoping to avoid multiple subpar test prints while i dial in the settings for the new resin
Bob Deblier
2020-03-18 21:24:41
Christopher King
the LED wasn't upgraded - just the original CBD mainboard replaced with the one from the Photon S.
Daniel Kottmair
2020-03-18 21:25:37
There is one on Thingiverse for the Fauxton S..
