I could use a little help interpreting this. Ran the exposure test off the Photonsters GitHub using Anycubic Grey resin. I've done a few prints that came out fine. The test cube came out great except for the lettering on the base seemed a little "squished". I've also attached the settings I used for that print, which I got off the online spreadsheet everyone references.
I've gotten these holes/bubbles in the base of every print so far and they showed up again on the exposure test file. Are these just air bubbles? The LCD and fep are clean and clear.
To me it looks like 7 has the best overall balance in this test but since I'm new I'd appreciate any thoughts or tips or confirmation.
翻譯年糕
Jay Starling
2020-02-25 06:02:05
Kyle Middleton
2020-02-25 06:03:08
Jay Starling
2020-02-25 06:07:32
Kyle Middleton
2020-02-25 06:08:04
Zena Andreou
2020-02-25 06:12:41
Kyle Middleton
2020-02-25 06:13:50
Zena Andreou
2020-02-25 06:17:47
Kyle Middleton
2020-02-25 06:41:34
