To prime or not to prime, that is the question. The reason I ask is because after printing two identical models with white resin I primed one using grey primer. On the other I went directly to a red base coat. The results? On the non primed model the red was vibrant after just one coat. The primed model however required 3 coats to archive the same result. Paint adhesion was the same on both models. All this brings me back to my original question - (other than when working with FDM prints) why prime?
翻譯年糕
Thomas Harrell
2020-02-16 14:54:07
Tyron Craft
2020-02-16 14:54:41
Tentin Quarantino
2020-02-16 15:00:10
Paul West
2020-02-16 15:17:03
Vincent Balmont
2020-02-16 17:40:43
Rene Canlas
2020-02-16 18:56:14
Jim Nelson
2020-02-16 20:14:51
Dominick Trascritti
2020-02-16 20:19:31
Cameron Surfass
2020-02-17 02:38:36
