Hello everyone. New here. I need some advice, as I am stuck failling wih this piece. It tends to peel of a little on one side every time, so the model deforms.
I use Anycubic grey. Room temp 20 celsuis.
I read and took notes on the leveling technique but now I have another doubts:
With a 0.03mm layer and 8 bottom layers, raft heigh should be 0.24mm?
Wich lifting speed do you use both for the bottom layers and normal layers?
Thank you all in advance!
翻譯年糕
Alex Bainbridge
2020-03-16 16:15:59
I had some lift for a while. I re levelled my bed and I pre warm my resin before printing in a warm water. I Aalto give it some extra heat as the build plate is lowering via a hair dryer just so to raise the ambient temperature inside a bit. Had 0 issues since I’ve started doing thay
Eduardo Vide
2020-03-16 16:19:18
Thank you! And what about the Chitu parameters?
Chris Holden
2020-03-16 16:26:25
I would rotate this piece nearly 90 degrees in the x axis; yes, you'll get support marks along one side, but stuff always prints better when you're building the model on top of itself, not trying to drag it out of the vat against its supports.
Merv Hinton
2020-03-16 16:34:53
Alex Bainbridge
2020-03-16 18:43:17
Eduardo Vide
these are my settings but I’ve only been printing about a month
Eduardo Vide
2020-03-16 18:46:08
Christopher Pearce
2020-03-16 18:52:57
You can always manually add larger supports on the side that lifts rather than the normal ones you are using in this problem area
Tom Sargison
2020-03-16 19:49:07
Eduardo Vide
2020-03-16 20:43:55
Thanks! I have been reading it and it was very helpful!
