Anycubic Photon Printer Owners 造訪社團

Hello everyone, I ask for help if you can help me
I can't print with the photon, that is, it only realizes the supports but not the object, what can it be?

翻譯年糕

This print has come out fine multiple times but the last two times, this has happened. It's not the same spot either. It just stops printing and hardens resin on the vat. Supports are intact on plate and no peeling. Any ideas?

翻譯年糕

What is going on? Last night I started a print before bed time. My 5 hour print did finish beautiful but most of the resin left from the print got hard in vat tank only on the button closed to Feb it was still lipuid my thoughts was this is strange. I removed all the resin there was hard in vat tank and immediately when it was removed the left over of the resin there still was lipuid got so hot there was coming smoke/steam and got so hot I couldn't put my finger on Feb more than 1-3 sec.

Does anybody have a good answer on what is going on?

翻譯年糕

Anycubic support doing them proud. Can't find my original post to update it but long story short I had a mark on the plate under the LCD and contacted them about it. Since they don't sell them they kindly sent me one along with 'some' (a whole roll !!) of tape to secure it. just over 10 days from Shenzen. Thanks Anycubic, I fully expected to pay for a new one but you offered it free before I even asked so very happy :)

翻譯年糕

Does anyone have info on the width and thickness of neoprene strips to use for the Photon door?

翻譯年糕

Hi everyone. I know this things are hard to get pics of and my slr is not setup yet but was hoping for some confirmation. i was printing a tricky miniature and some of the areas shifted a little and printed beside where it should be. was this due to my lack of setting up support properly?? just want to head in the right direction. Thanks :)

翻譯年糕

Any suggestions for this? These supports were on a 5mm loft height using ChiTuBox 1.5’s heavy default setting

翻譯年糕

How reliable is photon file validator for removing islands? Does it modify the print in a noticeable way when its only around 1-10 pixels?

翻譯年糕

Cast a plata con dos resinas resinworks violet y bluecast X10....no hay prácticamente diferencias, lo más importante es un buen fundidor, el otro fundidor salió todo con restos.

翻譯年糕

At this stage I'm not sure what is worse with my Photon, Having it delivered during the day so knowing it was just sitting at home for 5 hours waiting for me or now running a test print that is also going to take 5 hours...

翻譯年糕