Anycubic Photon Printer Owners 造訪社團

Do someone know how to set a older firmware on my photon original?

I wanted to test the new beta but not happy about it... Yes the printer makes less noise BUT some layers doesn't stick to each other. When I print something there are some gaps here and there

翻譯年糕

Talon troopers from Thingiverse. Printed at 0.05 with Elegoo grey. 2nd pic shows after removing supports- still have some cleanup to do - loving this printer!!

翻譯年糕

So this is a new problem to me, just replaced the FEP in one of my printers, tuned it to about 320htz, releveled but now the prints are coming out a bit weird and having some bits left over on the FEP afterwards as well.

First pic shows my good printer on the right and the left one is out of the printer I just replaced the FEP on. Second pic is an example of what gets stuck to the FEP, this is not a great example as there has been more on previous prints but it's always been really thin.

My best guess is that the leveling is too high, which means sometimes parts of a given layer get left behind on the FEP and depending on where in the print progress it's at, sometimes gets picked up be later layers instead of being left behind.

If that's the case, releveling should help but I was wo during if anyone has written guides for leveling out there? I do the paper method and far as I can tell followed through with it properly....

What do you guys figure?

翻譯年糕

First print I sliced myself off the Photon. I hit it with some high gloss clear coat after curing. Learned a ton about curing, cleaning and finishing. On to the next print!

翻譯年糕

Made a curing station out of an old boy scout popcorn tin. Pretty happy with it. Also, I'm loving this printer! Got a full build plate with stacking goblins in one go.

翻譯年糕

Remember the lamp? Well I finally painted it.
https://www.facebook.com/photo.php?fbid=2308868092504042

you can still see the facets

翻譯年糕

On order for curing my prints (once my printer comes in). Made sure the UV setup ran in the 405nm range. Also made sure it was "high power" just in case they over promised and under-delivered.

翻譯年糕

100/2/20 resin test. There's a tiny hole row 6, 3 down?? Any significance?? And if I'm reading this right (dim but nice) no. 7 would be ideal and I x 2 to give exposure of approx 14??? TIA

翻譯年糕

So, 5 guys on the plate. 3 turn out perfect, 1 has minor imperfections, 1 is a mess. The guy with the stick in his hand has some damage on the elbow and stick, that can be explained. But the guy that's supposed to hold a bucket turns out holding a shopping bag, and the close up of his legs shows that he's... shifted? How does that happen? How does the bucket turn out flat? And how do his knees shift like that, with the rest of the plate not being affected? Is it a support issue? Is it a fault in the sliced file? I can't explain that with my limited knowledge.

翻譯年糕