Anycubic Photon Printer Owners 造訪社團

Package finally came from monocure. Should last me for bout a year :D .

翻譯年糕

Finally getting my Falcon 1 printed

翻譯年糕

First ever print, and I used settings different from any in the spreadsheet, so I thought I'd share.

Model: Heroforge
Resin: Anycubic Green (the one that comes in the box)
Layer Thickness: 0.025mm
Normal Exposure Time: 14s
Off Time: 1s
Bottom Exposure Time: 50s
Bottom Layers: 8

翻譯年糕

Formlabs have the Preform Software ( freeware) you can have a Quick idea aboit position in sla or dlp if you are new this
Helpfull tricks for cleaning and positioning you can find there too
check the support infos
or :

翻譯年糕

Easy wireless file transfer for Photon.

Way back some, I thought a usb wifi flash storage device would be an easy solution to get wireless file transfer working. Of course you'd still need to walk over to your machine and physically press print, but this would eliminate the need to constantly plug and unplug your usb stick and the associated wear and tear.

Unfortunately, I bought a SanDisk Connect Wireless USB Stick, which doesn't work.

Thanks to Алексей Звездофф (sorry can't seem to tag you) I've finally found what is confirmed to work with our Photons. It's a Toshiba FlashAir wifi CF card, and you'd need an extra usb adapter to go with it.

https://www.facebook.com/groups/AnycubicPhoton/permalink/1540326196112017/

翻譯年糕

New question. I printed the one on the right at a 30° angle, the one on the left was flat to the base. The bottom on the right one is all goey and doesn't have the details of the flat one. Also it had weird distortions on the flat parts on the side. Any advice?

翻譯年糕

Update on hoggle still lots more to do looking forward to printing him on photon https://www.facebook.com/238088680200901/posts/269251337084635/

翻譯年糕

Best way to print something like this ? I'd ideally like to get as much onto the build plate as possible, so probably printing vertically, but i'm concerned the supports may not be enough to hold it to the plate mid print, i've tried printing direct on that plate, that worked but added some size distortion and would block some of the holes. Is best option to lift the model 5mm and then put a good amount of support below it ? (the model will be hollowed out).

Also, the resin is too brittle for the clips to work properly, they snap rather than bend like fdm abs would, would monocure flex be an option or should i just swap to using magnets and fix the pegs in.

Thanks

翻譯年糕