Anycubic Photon Printer Owners 造訪社團

I didn’t know that photon came with a free UV protector?! What a pleasant surprise!

翻譯年糕

What a difference a new LCD makes.

翻譯年糕

So I have a larger photon file then I have personally ever printed (22mb), and when I put the flash into the printer and click print, I see it as the only file on the drive but then the whole system stops up the flash drive just blinks. I can't see a preview for the file like usual. I have tried reformatting and putting the file back on there.

I feel like it's just "buffering" the file, and since it is a larger file it is taking longer? I'm not sure though, thoughts?

翻譯年糕

Hi all, where can I buy online bluecast x5 resin for dlp printers in Germany, Berlin. Hi all, where can I buy online bluecast x5 resin for dlp printers in Germany, Berlin. 翻譯年糕

What good resin options are there in the UK for:
- colourless clear
- strength (ABS like?)
- and flexible materials What good resin options are there in the UK for:
- colourless clear
- strength (ABS like?)
- and flexible materials 翻譯年糕

Question: anyone use meshmixer for supports? what are your settings

Ive been playing with it, but I can't seem to get it to chose the correct orientation for minimal support (upside down with the legs in the air) so I must have the weights wrong, and the support takes some tuning so I might as well ask :p

翻譯年糕

What do you think happened?
First of all, in the original file there is not the first layer that forms a film, it should be empty. (so I do not know why it behaves like that)
According to the piece I found it glued on the base, but to be so often, I think it has remained attached to the base for a while 'time and then it is detached.
The printer is calibrated and clean, so the sheet can come out by pulling but you can not push it.
I use isopropyl alcohol and a few drops of Rain off so that the piece is detached from the base during the initial phase. (otherwise it does not come off)
The settings are these:
- Layer thickness: 0.05
-Normal exposure: 12s
-Off time: 6.5s
-Botton exposure TIME: 100s
-Botton layers: 8
The press is in a room with an average of 12 degrees and relative humidity 50%
The resin is anycubic orange, but it is much more liquid than the original and the tips for printing are very similar.
I attach the link:
https://www.ebay.it/…/ANYCUBIC-Orange-Color-3…/264036072638…
Thank you so much for any help

翻譯年糕

Can anyone tell me were in Formware I can edit layer height and exposure times?

翻譯年糕

Not as fancy as a proper enclosure, but surprisingly effective! We got a piece of duct (about $10), 3D printed a thing to make it fit onto an old computer fan, and attached that into the window. With the end of the duct set next to the fan area of the printer it does a remarkably good job of removing fumes. I checked the flow using smoke from a candle and vapor from anywhere in that area is promptly sucked out the window.

翻譯年糕

Hey folks, first time buyer with a few questions; namely safety. I really wanted this to be my first printer so I can make my own toys since I do a ton of modeling, but I'm gonna be downgrading to a small studio apartment in the near future. Is the risk of fumes and stuff really gonna be that bad? Cause I was super determined to get this, especially knowing a lot of fdm printers wont get enough detail on figurines.

翻譯年糕