Anycubic Photon Printer Owners 造訪社團

I was interested in making a dice cage ( https://www.thingiverse.com/thing:2244984 ), but I wanted to scale it up. I'm not entirely sure how to do it and keep the scale of the lid and the cage consistent. Do you guys have any suggestions before I go and waste a bunch of resin? Also, does hollowing look necessary? I feel like it probably isn't.

翻譯年糕

So the other day I said I'd had my machine about 2 months.

About 70% perfect prints some possible human error.

I recently changed the FEP and did about 11 perfect prints. Then the next 3 were a bit off.

This morning I started using red resin instead of green and 4 perfect print runs.

Not too fussed, but it's very strange. All the time it's prints sticking to the fep instead of the plate or missed bits.

Flame tokens I did 5 minutes ago.

翻譯年糕

Is there a difference between the 2 sides of the FEP film or can I install it in any orientation ? Is there a difference between the 2 sides of the FEP film or can I install it in any orientation ? 翻譯年糕

My most successful print (primed in white).
However the orc warrior is very brittle. I dropped her on the ground from about 1m height and one of the arms fell off. Had to glue it back.
2 questions:
1) why brittle? Too much UV exposure? I exposed her about 40 minutes on 360nm uv (anycubic resin, rated for 405nm)
2) what glue to use? I used superglue but had to spend a lot of time waiting for it to actually stick.

翻譯年糕

BlueCast X5

翻譯年糕

Hi - can you help me please, what cause this? Partially missing supports in a few mm after base layers...?

翻譯年糕

Good day everyone,
I have a question regarding after print filling of hollow models.
I would like to print a small statue for outdoors. The print will be hollow with an open bottom, but I would like it to be heavy enough so that it will not be knocked down by mild winds.
What would be the best product to fill it with? I am guessing something that will not emit heat while curing and thus risk deforming the whole model.
Any ideas?

翻譯年糕

Why is this happening. Lifted even after sanding.
Plus the full FEP of thing resin.
Never used to get this.
Have tested the screen. Only shows the normal light test.

翻譯年糕

Guess who’s part of the club finally! Got it for an absolute bargain on eBay from very reputable seller. $432.25 after eBay coupon applied! Big upgrade from my sparkmaker DLP printer

翻譯年糕

Found this model ( https://www.thingiverse.com/thing:3156014 ) on thingiverse and he said, he would recommend to print him bigger than 11cm, as he did.

So I printed him 28mm with his shield. ? ?

Thanks jeebs08 for this model, dwarf2 will be printing soon.

翻譯年糕