Anycubic Photon Printer Owners 造訪社團

Duncan Louca's Fire elemental.

When preparing a model for slicing, is there an optimal angle for it to be positioned at relative to level? I get the impression that it should be tilted to some degree but I have found no such info on photonsters.org

Say I'm printing a small wrench, for instance. To what degree off of flat level should it be positioned for supports, etc?

翻譯年糕

The photon has been doing a really outstanding job since the 4th rebuild.. hope I didn't just jinx that.. the maroon SUCKs for Photography though..

翻譯年糕

Crosses 3cm height, settings 0.02/7.5/1.5/40/8

翻譯年糕

I'm so impressed with the results with this machine. Just shoving stls in there to learn by failing. Tried a cool model of a fallout power armor, though I'd surprise a friend who got the new miniature game.
The print came out looking so perfect, until I noticed the arms coming loose. Lokked more closely and realized it's a "wearable" model from the computer game, that means the chest, arms and legs are hollow. But the photon just printed it lik it was no big deal.
-Want a fully detailed power armor with space for a guy inside? 40mm high? Pshh, no problem, here you go!

翻譯年糕

Greetings fellow Photon enthusiasts! :) My husband and I are getting each other an early X-Mas gift of an Anycubic, so I was wondering where is best to order our baby from, Amazon or Aliexpress? I'm a big buyer on both platforms. IS there any difference?

翻譯年糕

Common crystal lattices printed with HARZ Labs Model White resin

翻譯年糕

Any ideas am using Anycubic green resin and this is my third attempt at print a model of the Eiffel Tower fails every time exactly the same as the picture. Have re-levelled etc etc.. am very new to this machine and any suggestions would be appreciated Thanks :-(

翻譯年糕

Hello Photonsters. So far, really loving my machine, no issues thus far, but I've only been printing at 50 micron layer heights. I'm learning about all of settings etc, so here is my question(s): At 25 micron, so you effectively half the exposure time per layer? Also, has anyone tried the technology outlet (UK) resin, if so how did you get on with it? I've tried some elegoo grey and got on great with it, very low odour compared with Anycubic stuff.

翻譯年糕

Hey guys, is there anyway to raise the height of the supports? It only seems to be dependent on what thickness you use but i would like to manually adjust the height if possible. Thank you!

翻譯年糕