Anycubic Photon Printer Owners 造訪社團

Have you guys tried the skin color Anycubic resin? Are the settings the same as for white? What about Aqua Blue? Have you guys tried the skin color Anycubic resin? Are the settings the same as for white? What about Aqua Blue? 翻譯年糕

What is the best clear flexible resin for Photon? I am looking for a truly clear result and as much flexibility as possible.

翻譯年糕

Perfect Dobby print. Anycubic Maroon. 0.05mm.

翻譯年糕

So what happened here? Overcured? Printer said it was done. Cleaned it in my ultra sonic directly after.

翻譯年糕

OMG loved the detail level!! # firstPrintSuccess

翻譯年糕

Results of my Ameralabs calibration test prints using monocure 3D rapid grey. 14 seconds exposure on 25 micron layers seems to be the sweet spot for printing details in this resin without artifacts from over exposure. I also like 18 seconds but the layers are a lot more visible in 18. 10 seconds and several features of the model didn’t print at all. Also ended up with congealed goop stuck to the bottom of the vat with 10. Note to self - more supports underneath will stop the sag! ?

翻譯年糕

Anyone have the laser cutting
template for the Polycarbonate Windows?

翻譯年糕

Is it common for lighter coloured resins to produce less dimensionally accurate prints? When using Anycubic Black I get very accurate prints but using white I have noted inside diameters shrinking by 0.5mm and outside diameters growing by 0.3mm, is this to be expected or is it bad settings?

翻譯年糕

So, how are you all cleaning the supports off your prints? I'm finding I either get holes because the support snaps off, or little bumps from cutting and filing the support down. I don't want to sand too heavily or I'll end up sanding away my details! Any tips greatly appreciated :)

翻譯年糕

.

"我想讓我們知道,

· 查看原文 · 為此翻譯評分