Anycubic Photon Printer Owners 造訪社團

My first successful print now fully painted and ready to play.

翻譯年糕

So assuming you could block 100% of uv rays from entering the printer, would it be okay to leave the resin in there or does it cure over time?

翻譯年糕

When everything comes together!!!!

翻譯年糕

I downloaded this dog (Thingiverse) and want it to have an open mouth before I print it on my Photon.

To change the mouth, would it require re-sculpting or would mesh manipulation be a better approach?

What program do you recommend learning that is an all rounder that covers both organic and hard surface modelling? I don't think my brain can handle leaning two or three programs at the same time ?

翻譯年糕

I have sent out some cudo's regarding the product support team at Anycubic. Within an hour they'd helped replace a part I damaged at a reasonable cost...

翻譯年糕

Latest print of a deadpool torso. Finally nailing the process/settings. Using wanhao red resin. Detail is insane.

翻譯年糕

Have those lucky draws received the resin gift? Welcome to post here and share your awesome and amazing printings? ? ? ?

翻譯年糕

So I printed a part in two halves with the intention to glue them together. I thought everything was properly supported, I had no errors in Validator, I used like 30% density supports, I thought the angle was good, and by all means the prints look GREAT. Except they warped.... about half of it fits together like a glove, and the other half has like a 2mm gap.. about 10 hours worth of printing down the drain.

Any idea what the hell happened?

翻譯年糕

Contest resin arrived!

翻譯年糕

That moment you realize you're out of resin and you don't have a replacement for your cloudy FEP...

翻譯年糕