Anycubic Photon Printer Owners 造訪社團

now this is sad. sorry if you cant read the page. thats the bbc for ya

翻譯年糕

Woot, got my printer, and calibrated it, but will need to wait to print till i can setup a ventilation system. i was able to print out (on my fdm printer) some vents that i can screw on to the back of the Photon and will make a window mount with a similar vent and use some 4" duct. But some ideas ive seen have people using big filters and fans and at $50 each, it seems a bit much to do that. Is there a slightly cheaper but just as effective way?

翻譯年糕

Hello all
I got my new Anycubic Photon. Face a problem. Home position of Z Axis is very low. At home position there is no gap between plate and LCD screen. Plate doesn't go down for level 0 settings. And it doesn't allow to set above home position. I have written to customer care but there respose is slow. Can anybody help me here? Thanks in advance

翻譯年糕

Simple question to all of you guys much appreciate the responses advance . What is the ideal amount the bit inside the top of the build plate should be tightened not the big red one one keeping it from falling off but the one that keeps it from wobbling .should I tighten with bit to max or leave some slack or what .thanks.

翻譯年糕

I need help why is it printing good then start sticking to the vat do I need to re level ?

翻譯年糕

My next print...i have no idea how i'm going to print it -_-
# AllForOne :p

翻譯年糕

Hello
I am doing my third print, is it normal that the resin stick so hard to the fep, that when the platform rises you can hear a loud Clack, also when printing the latice cube, the cube stretched a bit before leaving the fep, everyone the platform went up.
Maybe my platform is to low (bad leveled)?

翻譯年糕

? ? ? ? ? after 3 perfect back to back 4 hour prints half my screen just died!! I assume this needs a replacement?

翻譯年糕

Australia Aldi special buy, would make a good enclosure. fiddy bucks

翻譯年糕

Is this how a normal UV detection test should look like?

翻譯年糕