Anycubic Photon Printer Owners 造訪社團

Hi all.
I bought this third party flixable resin from ebay and used many settings none of them worked (the print keep stuck on the vat )

Did anyone used this resin? Any advice ?

翻譯年糕

My Aussie Rules Football Club emblem

翻譯年糕

Couple of questions:

Anybody know a good UK distributor of TEK 1969?

Any recommendations for a clear resin cheaper than the anycubic one?

翻譯年糕

Hi, some my today prints with a Photon, with a rest of Funtodo IB black, layer 0,04.
BTW, my problems with a casual restarts still persist, just sometime, almost EVERYTIME almost a first layer, Photon is freezes and restarts. Sometime not, but I can hear during build plate after a first layer "Home position" beep signal. Sometime no... :) I tried a new USB stick, short names, other power supp., Switch off for a few minutes before new print... Bu sometime it just works a few prints without any problem and sometime each print is with minimally one restart. Very frustrating... I think, that one reason is crappy USB cable from motherboard (I will change it) and next reason is "something" about safety switch inside a printer. When I move with a build plate (just 5x 10mm up for example) and during moving a build plate I will open a printer and move a little with a VAT, Photon freezes and restarts absolutely same like after a first layer. Off course, during printing is my VAT tighten by screws.
Mostly, after a printer restart after first layer, I just promptly run same print again (without a cleaning a build plate from a first layer) and it works.
It is just mystery... :(

翻譯年糕

Hi, need your help my Photon can't print stick build plate at all. Normally, I have to test machines before send to my customers almost my order number #92547574617539 working properly except this machine even do everything the same others machine but can't print stick build plate at all through last week.

翻譯年糕

HARZ Labs!!! Support diameter 0,4 mm.

翻譯年糕

Was very keen to post this!!! Here are the observations from our daily manufacturing practice!!!! The results of casting bluecast in 925 silver along with the casting of a normal castable resin!!! The results were damn astonishing and surprising, both were tested in our normal wax burnout cycle!!! The surface finish of bluecast us simply unmatched!!! Hope this post might save your ass from some of the hassle of finding the perfect castable resin!!!

翻譯年糕

Any pro tips for topping up resin during a print. Interested in ideas :)

翻譯年糕

That lion head ring thingomajoozit, cast from the anycubic green + wanhao black mix. Came ok, not ok enough to be considered financially viable ongoing, still bits of breakout, but if you on a budget and casting for yourself it will do in a pinch. Cast was regular 580 wax cycle.

翻譯年糕

So my photon arrived today but while I was unpacking I noticed a few small dents in the build plate, should I contact anycubic about a return or not worry?

翻譯年糕