Anycubic Photon Printer Owners 造訪社團

Does anyone place supports inside their hollow models? B9 auto generates them inside and I was just deleting them...but now I wonder if I should have left them....I feel like I don't care about misprints inside right? It shouldn't cause a failure, just artifacts?

翻譯年糕

Quick question about ambient temperature. I like to put my printer on the balcony to avoid stinking up my apartment with resin (I cover it with a bag to avoid UV exposure). However, it’s been well over 90 Freedom units (or mid to upper 30s celsius for the rest of the world) here. Do the high temps impact the printing process or the resin?

翻譯年糕

hello guys, me again. any tips? already sanded (a bit) and leveled. disassembled and reassembled the build plate, but large prints are getting me mad. only one corner collapses. try to print more distance from buildplate? ? monocure clear resin

翻譯年糕

After around 20 hours of total printing the screen did not seem to work anymore. I rebooted a couple of Times and now it works again. Should I be worried or can this bug happen?

翻譯年糕

If a print doesnt finish before I have to leave for the night is it ok to leave in the printer for 12 hours?

翻譯年糕

Getting a squeaking noise when the plate goes down might be the screw needing lubrication, any recommendations?

翻譯年糕

has anyone tried to print with two colours to create a marble effect? If so how have you done so?

翻譯年糕

Well happy! The proof is in the next prints of course but so far (touch wood) it's looking very promising.
Bought a cheap ultrasonic machine from Amazon and as I don't have any Ziploc bags made do with a tie top freezer bag. 3 mins in the cleaner, run under warm water then cured under a tiny UV nail lamp (must get a better one!). I'll sun-cure it tomorrow too just to be safe but it looks straight, adhered to the plate just the right amount and I can't see any issues on the model.
Now to take this seriously, download the software and learn how to actually set things up properly for the machine!

翻譯年糕

Guess I probably won't get any printing done tonight... ?

翻譯年糕

Another silly simple question that's not covered in the instructions: how do I remove the build plate from the printer after a print?
I've a lovely cube model printed (looks good upside down anyway) but loosening the big red knob doesn't let me slide the plate off. Do I have to undo the allen bolt used to level the plate to get it out, or should I try to pop the print off while it's still in the machine? What am I missing?
Feel a bit of an idiot having to ask!

翻譯年糕