Anycubic Photon Printer Owners 造訪社團

Anyone tried curing your part in a microwave in a metal pan? This guy has! >.<

翻譯年糕

10% Discount on Resin, FEP and most other products ends September 1th. Use coupon 'fepyday2018'
www.fepshop.com

翻譯年糕

Short Update.. Slightly turning the parts in Z Angle direction seemed to have fixed my dimensional accuracy problems.. its strange but it seems to be true..

翻譯年糕

Eventually printed after couple of attempt, more parts is printing...... finger crossed ......

0.05 @ 12 sec Anycubic Resin

翻譯年糕

Hey all now that anycubic has a small discount in aliexpress I see that we can get the resin the same price as the monocure. Comparing those 2 which as read are the best for our printer, which one would you recommend? Use case for me are tabletop minis. Color is irrelevant since I prime them anyways

翻譯年糕

I wand to buy sla printer
I want to choose between flyingbear shine or anycubic
Please guide
Thank you in advance

翻譯年糕

Do you leave your photon running overnight? I don't see any obvious reasons why you couldn't or wouldn't. By design, it seems like it would be inherently safer than say leaving an FDM printer going overnight.

翻譯年糕

Iv had my photon for a week now and iv done 3 prints on it which where successful. Now when tried to print, nothing and iv done uv detection test and i no longer see the outlined test shape. Also tried update firmware then tried uv test again and still does not display any shape.

翻譯年糕

Good morning photonsters, Full story is here!!!! (watch till the last picture), final product is just acid treated ~ no polishing post production work done yet!!! Also have a look at the 20x magnification result # BLUECASTX5 # BLUECAST # pch3d

翻譯年糕