Anycubic Photon Printer Owners 造訪社團

First print!

翻譯年糕

Issue need help. They are all good till about 1 inch down then it seems to increase in width for the rest of the way. Using monocure rapid white worried that monocure may be crap and may have to go back to anycubic resin

翻譯年糕

any special adjustment for flexible resin? thanks guys any special adjustment for flexible resin? thanks guys 翻譯年糕

He guys, got a little problem again.. ??‍♂️ anyone who knows what is causing the line around the elephant? It even caused the ear to fail..

Also, the legs should move but they do not. I think it's because it's printed too small but I would like to hear your opinion ?

翻譯年糕

Alright..i was excited to get the Printer, but i most say..i read so much horror stories, not sure if i want to get it anymore?..lol...does anyone actually uses it without issues?

翻譯年糕

what's everyone's preferred place to buy resin? what's everyone's preferred place to buy resin? 翻譯年糕

Hi everybody.

still no lu!ck to print with anycubic black resine.
i'm using following settings from the spreadsheet
Anycubic Black 0,025 7,5 3,5 90 3
all i get is the first layer on build plate, but as soon as the support start to be printed it fail.
no problem with green resin
leveling dubble checked

should be missing something but don't know what

翻譯年糕

Having the hardest time with the Wanhao Black Resin.. The raft seems to print just fine.. but the supports are not there (it seems completely flat as if it didn't even print the supports at all). Also it is almost like water (low viscosity). Any experience with this ?

翻譯年糕

Just got it and the test print worked pretty good. Trying to print my own file - slicer works creates the file and when I try to print the percentage goes to 99% and then just sits there doing nothing? Help?

翻譯年糕

Hi everyone, I have a printer (PHOTON) for a couple of weeks. Having problems printing (always in the same place) I came to check that the exposure was fine. I think there is something wrong, only half of the test appears on the LCD. attached photo. Someone can give me some advice on what to do? are there any parts to replace? maybe I still use the guarantee? ... thanks

翻譯年糕