Anycubic Photon Printer Owners 造訪社團

Hi, does anyone know where I can get the antlabs validation model file?

翻譯年糕

what flexible resin works well with photon ?

翻譯年糕

I’m testing out printing some parts with Photocentric High Tensile Strength resin, and the instructions call for post-cure at 80C for 2 hours. I could get a Form Cure for over $600, or...hot plate, Pyrex measuring cups, UV leds. I already had the hot plate, so I think I spent $35 (for two “cure stations”) . We’ll see how it goes.

翻譯年糕

Finally... crossing fingers

翻譯年糕

Nice Morgan Morey Vader from Myminifactory.
Done with Monocure Rapid clear and black Dye.
0.05mm, 12sec, 1sec off, 80sec bottom, 6 layers

翻譯年糕

Hello all. Getting Photon tomorrow. Curious about visual resolution lines... quality level settings... people’s opinions?

翻譯年糕

Hey guys can I get some assistance in reading this exposure test thankyou in advance

翻譯年糕

Wanhao orange---any good settings as i dont see it on the resin
page..Thanks

翻譯年糕

I remixed a VAT lid for the Photon so it can just lay on top of the VAT and not use the thumb screws which would force a re-level.

翻譯年糕

So looking for a little help on this one. Got the Photon today and did the calibrations, installed the software and every time I try to run it I get the attached error message. I've reinstalled it and still same message.

Tried running as admin and same thing. Looked the message up on google and pointed to an update that won't install. Any others have this issue and if so how'd you fix / get around it?

翻譯年糕