Anycubic Photon Printer Owners 造訪社團

Got my Photon bed set, level and I have an issue where the platform goes into the vat to the film level for first layer just fine. Then each layer after the platform is about 1.5 cm from the film. I have had all my test prints failed then noticed the platform was not going into the resin from layer 2 forward. Any ideas?

翻譯年糕

Senertek white resin. Finally had some time to test this out. First it arrived from Turkey via DHL. Came in just a plastic bag, no padding or anything. I was a little worried when I opened it, but everything was ok and intact. The model in the picture was printed at .050 resolution, with 22 second exposure times. I like the ivory color and the feel of the resin is like porcelain. Very nice in my opinion. The exposure time is just too long for me. I will use this on small items, but will stick with Monocure Rapid as my main resin.

翻譯年糕

Has anyone tried wanhao orange resin or can recommend wanhao resin cheers

翻譯年糕

Trying to see how well some clear works out on some prints that ran last night. It was a great photo... Untill the wind blew past(see last photo as it tumbles off).

翻譯年糕

It just never ends. 2 days of prints finally cured and ready for adding to sets.

翻譯年糕

Is there any way to estimate how much resin needs to be in the vat before starting a print? Is there any way to estimate how much resin needs to be in the vat before starting a print? 翻譯年糕

This is supposed to be the bottom base of the supports being printed.the bottom should be extending more to the left in the picture. Any idea why it isn't printing all of it right now? Was the model stl i saved not flat in the program?

翻譯年糕

The glass bowl I use to dunk the model in iso has some resin build up. I put it outside and let the iso evaporate and the resin cure. How do I clean the now cured resin from the bottom on my glass bowl?

翻譯年糕

New FW?

翻譯年糕

Bad batch of included Anycubic green resin? I had several bad prints of the demo model. They all failed at their weak point, just after the base (after which the rest of the model consistently stuck to the fep). Did several relevels, as wel as the Flint method. Nothing worked. After the last try with Anycubic green Resin I switched to Monocure Rapid Clear and had instant success! (Between the last print with Anycubic resin and the print with Monocure, I did not change anything, I did not relevel and did not change the FEP sheet, room temp was the same and both bottles were well shaken before print.) Was my batch of anycubic green resin bad?

翻譯年糕