Anycubic Photon Printer Owners 造訪社團

Any tips to clean the FEP better? Any replacement ones that might work better? All I've done is the alcohol (91) and paper towl. Im on the last of my sample resin and would rather wait if this will effect my print?

翻譯年糕

Hi all. I leveled the using the Reed method and my print came out, however some supports in the middle of the object didn't render full length and one corner of the box cured up (almost like on an FDM printer where the head was too high off the plate). I did notice some diviots in the fep as I was cleaning it out, but I'm not sure if the model was orientatint over them or not. Could that have the cause of my issue, or would it be something else?
I wasn't able to grab a picture as my phone wasn't on me and i was rushing for work.

翻譯年糕

I love my new Anycubic. And I really enjoy this forum. Lots of good info. I’ll be posting pictures soon. I’m waiting for my Bluecast castable resin shipment from Italy. So far I’ve only used the green resin that came with the printer and I’m blown away by the results. Best wishes for all!

翻譯年糕

So this was a 4 hour print :/

Not sure what happened

翻譯年糕

My challenge to Anycubic:

Use a screen the size of an iPad and...GO!

Watch them fly off shelves with that build volume!!!!

翻譯年糕

I saw a few videos about the LCD glass under the vat lifting and the suggestion of taping the edges down. Has anyone tried adding a slightly larger tempered glass cell phone screen protector over it that would also overlap the edges?

翻譯年糕

Ok a little bummed and feeling like a total noob. So I loaded up my very first print on the usb drive last night, plugged it in to the printer, hit print and went to bed. This morning when I woke up I went to get them as I was super excited to see how they turned out and...nothing. Absolutely nothing on the build plate. Any ideas on what I did wrong? I followed he initial setup instructions to the letter, or at least I thought I had. I want to try it again when I get home from work but wanted to run this by the group before I did so I don’t make the same mistake twice. Any and all help is much appreciated.

翻譯年糕

Can you see into the printer a lot better with orange panels? Also has anyone actually had resin go off with the stock blue panels? Could someone with orange panels put a drop of resin on the top of the build plate and put the machine out in the sun for a couple of hours? If that's ok it's probably fine to leave resin in the vat inside for a month or so...

翻譯年糕

Well, here she is! Printed at 0.05 with anycubic green and using the sheets settings.

翻譯年糕

My first complete “Print n Paint”...

Nothing fancy, starting off small, hold your applause, lol.

I can already see being FULLY addicted to making my own stuff to paint... time to fire up ZBrush again.

翻譯年糕