Anycubic Photon Printer Owners 造訪社團

Could someone test the following file? My printer cuts around 4mm in Y axle and 2mm in X axle, and I don't know if this is normal or can be fixed with a newer version of firmware. The main problem is that slicer do not provide any warning.
As you can see the STL file contains an elipse that fills the entire active area (120,96mmx68,04mm). The slicer does not show red walls and slice preview is OK, but when printed the edges are cut.
Is also possible to test with a dry run checking if the LCD shows the full elipse or it is cutted.

翻譯年糕

The Big Sale on ANYCUBIC Aliexpress store. Photon and Mega are available at low prices. ?

By the way, the ultrabase giveaway activity will be held tomorrow. ?

翻譯年糕

Hey guys having some trouble at the moment had some really good prints with anycubic green then the last print with it failed much the same as this one did. My supports are sticking to the build plate but the actual print it's self which is a miniature from my hero forge is sticking to the vat. This prints with the monocure rapid red and I used the settings in the spread sheet. I even tried upping the normal exposure time to 12 seconds to see if that's why it was breaking away. I have releveled a few times and cleaned the vat. I layed this print down on its back and used mesh mixers recommended supports to see if that helped. Even tried printing some prints that I have had work perfectly fine in the past but have all broken away from the supports. Anyone have any ideas?

翻譯年糕

"The bearded yell" in monocure black
Drying and curing and looking really good
More pics to follow

翻譯年糕

First attempt and 30mm D&D miniatures
Will follow up with more photos of the cleaned up prints

翻譯年糕

First coat of paint - gold
Still got more to do + add the helmet

翻譯年糕

Request for photonista's in/near The Netherlands:
What's the best Opaque Black resin you can get for a reasonable price here?

翻譯年糕

Carton Network & myminifactory seem to have a deal to publish adventure time models but I didnt thought LSP was so big ;_; fdm & sanding it is.

翻譯年糕

Thanks for add.
After a few prints I got this result. It will print exactly only the half side. Did anyone have this phenomenon? It seems the half side of the LCD has failed. After three try without success I gave up. I have the photon for a week now. Is this a case for warranty or am I doing something wrong?

翻譯年糕

Cherry resin and lost wax casting

翻譯年糕