Anycubic Photon Printer Owners 造訪社團

原文網址 Tan Yan Liang
2018-06-10 00:19:47

I was inspired to build a carbon air filter for my Photon, but unfortunately many of the choices for duct fans on amazon only come in 110 V.

Would anyone know where I can get a duct fan for 230 V?

翻譯年糕

原文網址 Rick Graham
2018-06-10 00:19:05

Alright, so life got busy for a bit so I had to take a break from learning how to properly use my Photon.

So I am doing some more test prints with multiple pieces on the build plate at the same time. Some of my prints are sticking while some are not. I can't figure out what the problem is, any likely issue I am entirely missing?

**the build plate is level**

翻譯年糕

原文網址 Laurentiu Neagu
2018-06-10 00:07:12

Top tip for those living in a house, next to a beach (or with a sandbox readily available) - to save some alcohol when you plan on cleaning the spatula, your hands or the recipient you clean the plate in, use sand. Cover in sand, and simply rub it off. Do it a couple of times and all the sticky stuff goes away rather cheaply. Have fun! (oh, I do it all the time, is fully tested)

翻譯年糕

原文網址 Caine Dixon
2018-06-09 23:40:43

Thanks for the add! This is a new hobby for me so be prepared for what will possibly be stupid questions!

翻譯年糕

原文網址 Philippe Maegerman
2018-06-09 23:29:54

Cheeky monkey :P
I used the configuration.gcode to change peel height to 3mm instead of 6mm and peel speed to 3 instead of 2, goes faster and no problem.
FunToDo snow white with a bit of blue pigment
0.05mm layer height 12s/layer
Maybe a little bit overcured ...
https://cults3d.com/en/3d-model/art/cheeky-monkey

翻譯年糕

原文網址 Joe Broggio
2018-06-09 23:28:36

How long do you guys typically post-print UV cure for?

翻譯年糕

原文網址 Flint Read
2018-06-09 23:22:37

Anyone have a cr10 or similar that could print this for me? I have the files.

Willing to pay :D

翻譯年糕

原文網址 Paul Woodroffe
2018-06-09 23:00:52

Hi everyone.
I received my printer yesterday and while the one successful print was absolutely superb in quality I've had some fails. I have changed now to Monocure Rapid White, and used the settings from the Google table to set it up, but as you can see it has failed pretty miserably.
The green is a partially successful print using the original resin from AnyCubic, the white is obviously the failed print. I thickened up the walls for the new print in order to make it more robust, but as you can see it appears to have failed with even more gusto!

Can anyone give a newbie some pointers please?
Thanks

翻譯年糕